Filter
Top Products
Networking
Configuring Quality of Service
Cisco ISA500 Series Integrated Security Appliances Administration Guide 156
4
STEP 3 Click Save to apply your settings.
Configuring WAN QoS
This section describes how to configure WAN QoS. Refer to the following topics:
• Managing WAN Bandwidth for Upstream Traffic, page 156
• Configuring WAN Queue Settings, page 157
• Configuring Traffic Selectors, page 158
• Configuring WAN QoS Policy Profiles, page 160
• Configuring WAN QoS Class Rules, page 160
• Mapping WAN QoS Policy Profiles to WAN Interfaces, page 161
• WAN QoS Configuration Example, page 162
• Configure WAN QoS for Voice Traffic from LAN to WAN, page 164
• Configuring WAN QoS for Voice Traffic from WAN to LAN, page 165
Managing WAN Bandwidth for Upstream Traffic
Use the Bandwidth page to specify the maximum bandwidth for upstream traffic
allowed on each WAN interface.
STEP 1 Click Networking > QoS > WAN QoS > Bandwidth.
STEP 2 Enter the amount of maximum bandwidth for upstream traffic allowed on each
WAN interface. The default value is 6000 Kbps, which indicates that there is no
limit for upstream traffic.
STEP 3 Click Save to apply your settings.