Filter
Top Products
Configuration Wizards
Using the Setup Wizard for the Initial Configuration
Cisco ISA500 Series Integrated Security Appliances Administration Guide 38
2
NOTE: You can configure your Cisco.com account credentials on the Device
Management > Cisco Services & Support > Cisco.com Account page after the
Setup Wizard is complete. See Configuring Cisco.com Account, page 424.
STEP 5 If your Cisco.com account credentials are invalid, click OK to return to the
Cisco.com Credentials page. Correct your Cisco.com account credentials and
then click Next to verify them again.
STEP 6 If your Cisco.com account credentials are valid, proceed to the Upgrade Firmware
page.
Enabling Firmware Upgrade
STEP 7 Use the Upgrade Firmware page to enable the device to check for firmware
updates or to manually upgrade the firmware.
• To automatically check for firmware updates, check the box next to Check
for firmware update when Setup Wizard completes. The security
appliance will immediately check for firmware updates after the Setup
Wizard is complete. This feature requires that you have an active WAN
connection.
• To manually upgrade the firmware from a firmware image stored on your PC,
uncheck the box next to Check for firmware update when Setup Wizard
completes. Uncheck this box when you do not have an active WAN
connection and you have already downloaded the latest firmware image
from Cisco.com to your local PC.
STEP 8 If you uncheck the box, click Browse to locate and select the firmware image from
your PC, and then click Upgrade.
After you click Upgrade, the security appliance starts installing the firmware. This
process will take several minutes. Do not disconnect the power or reset the
device. Doing so will cancel the firmware upgrade process and could possibly
corrupt. The security appliance reboots after the firmware is upgraded. You will
be redirected to the login screen when the security appliance boots up.
STEP 9 If you choose to automatically check for firmware updates, click Next.