Filter
Top Products
Configuration Wizards
Using the Wireless Wizard (for ISA550W and ISA570W only)
Cisco ISA500 Series Integrated Security Appliances Administration Guide 78
2
Specify Wireless Connectivity Settings for All Enabled SSIDs
STEP 7 Specify the wireless connectivity settings for all enabled SSIDs.
• For complete details to configure the connectivity settings for Intranet WLAN
access, see Configuring the SSID for Intranet WLAN Access, page 78.
• For complete details to configure the connectivity settings for Guest WLAN
access, see Configuring the SSID for Guest WLAN Access, page 80.
STEP 8 After you are finished, click Next.
Viewing Configuration Summary
STEP 9 Use the Summary page to view information for the configuration.
STEP 10 To modify any settings, click Back. If the configuration is correct, click Finish to
save your settings.
Configuring the SSID for Intranet WLAN Access
Follow these steps to configure the connectivity settings for Intranet WLAN
access.
STEP 1 Enter the following information:
• SSID: Enter the name of the SSID.
• Broadcast SSID: Check this box to broadcast the SSID in its beacon frames.
All wireless devices within range are able to see the SSID when they scan
for available networks. Uncheck this box to prevent auto-detection of the
SSID. In this case, users must know the SSID to set up a wireless connection
to this SSID.
• Station Isolation: Check so that the wireless clients on the same SSID will
be unable to see each other.