Filter
Top Products
Getting Started
Performing Basic Configuration Tasks
Cisco ISA500 Series Integrated Security Appliances Administration Guide 32
1
green. Release the button and wait for the unit to reboot. The POWER/SYS
light will flash green when the system is rebooting.
• Or launch the Configuration Utility and login. Click Device Management >
Reboot/Reset in the left hand navigation pane. In the Reset Device area,
click Reset to Factory Defaults.
After a restore to factory defaults, the following settings apply:
Performing Basic Configuration Tasks
We recommend that you complete the following tasks before you configure the
security appliance:
• Changing the Default Administrator Password, page 32
• Upgrading your Firmware After your First Login, page 33
• Backing Up Your Configuration, page 34
Changing the Default Administrator Password
The default administrator account (“cisco”) has full privilege to set the
configuration and read the system status. For security purposes, you must change
the default administrator password at the first login.
STEP 1 Enter the following information:
• User name: Enter the current username or enter a new username if you want
to change the default username.
Parameter Default Value
Username cisco
Password cisco
LAN IP 192.168.75.1
DHCP Range 192.168.75.100 to 200