Filter
Top Products
Device Management
Diagnostic Utilities
Cisco ISA500 Series Integrated Security Appliances Administration Guide 429
10
NOTE These features require an active WAN connection.
Ping
Use the Ping page to test the connectivity between the security appliance and a
connected device on the network.
STEP 1 Click Device Management > Diagnostic Utilities > Ping.
The Ping window opens.
STEP 2 Enter the following information:
• IP Address or URL: Enter the IP address or URL to ping.
• Packet Size: Enter the packet size in the range 32 to 65500 bytes to ping.
The security appliance will send the packet with the specified size to the
destination.
• Number of Pings: Enter the times to ping. The security appliance will send
the packet for specific times to check the connectivity with the destination.
STEP 3 Click Start to ping the IP address or the URL, or click Stop to stop pinging.
Traceroute
Use the Traceroute page to view the route between the security appliance and a
destination.
STEP 1 Click Device Management > Diagnostic Utilities > Traceroute.
The Traceroute window opens.
STEP 2 Enter the following information:
• IP Address or URL: Enter the IP address or URL of the destination.
• Maximum Number of Hops: Choose the maximum hop number.
STEP 3 Click Start to trace the route of the IP address or URL, or click Stop to stop tracing.