Filter
Top Products
Device Management
Administration
Cisco ISA500 Series Integrated Security Appliances Administration Guide 408
10
• HTTPS Listen Port Number: If you enable remote management by using
HTTPS, enter the port number. By default, the listen port number for HTTPS
is 8080.
• HTTP: Click On to enable remote management by using HTTP, or click Off to
disable it.
• HTTP Listen Port Number: If you enable remote management by using
HTTP, enter the port number. By default, the listen port number for HTTP is
80.
• Allow Address: To specify the devices that can access the configuration
utility through the WAN interface, choose an Address Object or enter an
address.
- Address Objects: These objects represent known IP addresses and
address ranges, such as the GUEST VLAN and the DHCP pool. For details
about the listed Address Objects, see the Networking > Address
Management page.
- Create new address: Choose this option to enter an IP address or
address range. In the pop-up window, enter a Name and specify the
Type (Host or Range). For a single host, enter the IP address. For a range,
enter the Starting IP Address and the Ending IP Address.
• Remote SNMP: Click On to enable SNMP for the remote connection, or click
Off to disable SNMP. Enabling SNMP allows remote users to use SNMP to
manage the security appliance from the WAN side.
STEP 3 Click Save to apply your settings.
Configuring Email Alert Settings
Use the Email Alert page to centrally configure how to send the alert emails to the
operator or administrator for specific events or behaviors that may impact the
performance, operation, and security of your security appliance, or for debugging
purposes.
When this feature is enabled, an alert is sent under these three conditions:
• The Web URL categories are changed.
• The Security Services application server status is No Authentication
because the server is offline.