Filter
Top Products
Configuration Wizards
Using the DMZ Wizard to Configure DMZ Settings
Cisco ISA500 Series Integrated Security Appliances Administration Guide 71
2
• If you only want to create the IPsec VPN policy and do not want to
immediately activate the connection after the settings are saved, click Do
Not Activate. The connection will be triggered by any traffic that matches
this IPsec VPN policy and the VPN tunnel will be set up automatically. You
can also go to the VPN > Site-to-Site > IPsec Policies page to manually
establish the VPN connection by clicking the Connect icon.
Using the DMZ Wizard to Configure DMZ Settings
Use the DMZ Wizard to configure DMZ and DMZ services if you need to host
public services. Refer to the following steps:
• Starting the DMZ Wizard, page 71
• Configuring DDNS Profiles, page 71
• Configuring DMZ Network, page 72
• Configuring DMZ Services, page 74
• Viewing Configuration Summary, page 76
Starting the DMZ Wizard
STEP 1 Click Configuration Wizards > DMZ Wizard.
STEP 2 Click Next.
Configuring DDNS Profiles
STEP 3 Optionally, use the DDNS Setup page to configure the DDNS profiles for remote
management of the DMZ network.
NOTE: Up to 16 DDNS profiles can be configured on the security appliance.
STEP 4 Click Add to create a DDNS profile.
Other options: To edit an entry, click the Edit (pencil) icon. To delete an entry, click
the Delete (x) icon.