Filter
Top Products
Configuration Wizards
Using the Wireless Wizard (for ISA550W and ISA570W only)
Cisco ISA500 Series Integrated Security Appliances Administration Guide 77
2
- 802.11b/g/n mixed: Choose this mode to allow 802.11b, 802.11g, and
802.11n clients operating in the 2.4 GHz frequency to connect to the
access point.
- 802.11n only: Choose this mode if all devices in the wireless network
can support 802.11n. Only 802.11n clients operating in the 2.4 GHz
frequency can connect to the access point.
• Wireless Channel: Choose a channel from a list of channels or choose Auto
to let the system determine the optimal channel to use based on the
environmental noise levels for the available channels.
STEP 4 After you are finished, click Next.
Configuring Wireless Connectivity Types
STEP 5 Use the Choose SSIDs page to enable and configure the SSIDs that you want to
use.
• Enable: Check this box to enable the SSID.
• Mode: Choose the wireless connectivity type for each enabled SSID.
- Intranet WLAN Access: Allows the wireless users to access the
corporate network via the wireless network. By default, the WLAN is
mapped to the DEFAULT VLAN.
- Guest WLAN Access: Only allows the wireless users who connect to the
guest SSID to access the corporate network via the wireless network. By
default, the WLAN is mapped to the GUEST VLAN.
- Captive Portal Access: Only allows the users who have authenticated
successfully to access the corporate network via the wireless network.
The wireless users will be directed to a specific HotSpot Login page to
authenticate, and then will be directed to a specified web portal after
login before they can access the Internet.
NOTE: Only one SSID can be set for Captive Portal access at a time.
STEP 6 After you are finished, click Next.