Filter
Top Products
VPN
Configuring a Site-to-Site VPN
Cisco ISA500 Series Integrated Security Appliances Administration Guide 342
8
• WAN Interface: The WAN port that traffic passes through over the IPsec
VPN tunnel.
• Peers: The IP address of the remote peer.
• Local: The local network of the local peer.
• Remote: The remote network of the remote peer.
• IKE: The IKE policy used for the IPsec VPN policy.
• Transform: The transform set used for the IPsec VPN policy.
STEP 2 Click On to enable site-to-site VPN, or click Off to disable it.
NOTE: Enabling the Site-to-Site VPN feature will disable the Teleworker VPN
Client feature.
STEP 3 If you enable site-to-site VPN, perform the following actions:
• To add a new IPsec VPN policy, click Add. See Configuring IPsec VPN
Policies, page 343.
• To edit an existing IPsec VPN policy, click the Edit (x) icon.
• To delete an IPsec VPN policy, click the Delete (x) icon.
• To delete multiple IPsec VPN policies, check them and click Delete.
• To enable an IPsec VPN policy, check the box in the Enable column.
• To manually establish a VPN tunnel, click the Connect icon for an enabled
IPsec VPN policy.
• To manually terminate a VPN connection, click the Disconnect icon.
• To refresh the data for site-to-site VPN, click Refresh.
STEP 4 Click Save to apply your settings.