LG Electronics STB-2000 DVR User Manual


  Open as PDF
of 86
 
20
206-4256
EZ-Manager Wizard (Cont.)
(Continued from previous page)
Note: If, aftercompletingthesearch,theSTBisunabletond
the Pro:Centric data channel (while the Searching for Pro:Centric
Server screen is on display), the wizard will stop and show a
Diagnostics screen that enables you to manually return to the
previousscreen(toreinitiatetheconguration)orexitthewizard.
WhenthePro:CentricCongurationiscomplete,anEZ-Manager
CongurationCompletescreenisdisplayed,andafter10
seconds, the wizard exits, and the STB turns OFF.
Note:WiththeEZ-ManagerCongurationCompletescreenon
display, you can also manually turn off or reboot the STB. If
desired, select Turn Off or Reboot, respectively, and then press
OK on the Installer Remote.
Manual Pro:Centric Conguration
1. With the Searching for Pro:Centric Server screen on display,
use the arrow keys on the Installer Remote to select/highlight
the Manual Pro:Centric option at the bottom right of the
screen, and press OK.
In the Pro:CentricManualCongurationscreen(seeexamples
at right below and on following page), you will be able to
conguretheappropriatePro:CentricsettingsintheSTB.Use
the Up/Down arrow keys on the Installer Remote to navigate
betweenelds.
2. InthePro:CentricModeeld,usetheLeft/Rightarrowkeys
to select the appropriate Pro:Centric Application Mode—
GEM,FLASH,HTML,orCongurationOnly.
Note:Forremotemanagementonly,select“Conguration
Only.” The STB will search for TV E-Z Installation data
downloads; however, Pro:Centric application data will not be
downloaded, i.e., Installer Menu item 098 PRO:CENTRIC
will be set to 0.
3. Refer to the appropriate subsection below, depending on the
Pro:Centricserverconguration,tocompletetheremaining
elds.
RF Conguration
a) In the Media Type eld,use the Left/Right arrow keys to
select RF.
b) IntheDataChanneleld,eitherkeyinorusetheLeft/
Right arrow keys to select the RF channel number that
will be used by the Pro:Centric server as its data channel.
The Data Channel value can be set from 1 to 135. *
* PCS150R and later Pro:Centric servers do not support HRC or IRC cable channel frequencies.
Z
EZ-Manager Wizard
Back
Manual Pro:Centric
4
3
2
1
Searching for Pro:Centric Server...
Exit
It may take 1 min 32 second(s).
This step automatically searches for the Pro:Centric server.
If there is no Pro:Centric Server installed, you do not need to continue
with this procedure. Please select either ‘Exit’ or ‘Manual Pro:Centric’.
Status : Tuning channel 49
TV is now searching all of the channels for the data channel...
(Continued on next page)
EZ-Manager Wizard
Pro:Centric Mode
Media Type
Data Channel
Signal Strength
Signal Quality
RF
GEM
< >
Back
Next
Exit
Pro:Centric Manual Configuration
0%
0%
No signal
1
Pro:Centric Manual Configuration Screen with
RF Media Fields
4
3
2
1
EZ-Manager Wizard
EZ-Manager Configuration Complete
Pro:Centric Application
Maintenance Files
GEM application downloaded
STB-2000_Config.tlx
Installed Components
2
1
3
The TV will turn off in 3 second(s).
4
Reboot
Turn Off
 previous next