LG Electronics STB-2000 DVR User Manual


  Open as PDF
of 86
 
36
206-4256
Custom Master STB Setup (Cont.)
Custom Master STB Setup Procedure
1. Turn ON the STB/display panel.
The next step depends on whether the EZ-Manager Wizard appears on
the screen when you turn ON the STB/display:
• If the wizard is displayed, the STB is in the required factory default
state. Exit the wizard, and then continue with step 2.
• If the wizard is not displayed, restore the STB to a factory default
condition before continuing with this procedure. See Reference section,
“Restoring Factory Defaults on the STB(s),” as necessary, for further
information.
2. Set Installer Menu items.
ThisstepprovidesspecicinstructiononlyontheInstallerMenuitems
that should be set on a Master STB. Refer to pages 25 to 34 for detailed
information on all Installer Menu items.
a) Use the Installer Remote to access the PTC Installer Menu (see
“Accessing the Installer Menu” on page 25 for further information).
b) Set Installer Menu item 003 BAND/AFC, as appropriate.
• Broadcast: Set to 0. • HRC: Set to 2.
• CATV: Set to 1 (default). • IRC: Set to 3.
c) Set any other Installer Menu items that affect your TV programming
network totherequiredconguration.Forexample,setthepanel
display type (if applicable), enable/disable Aux inputs, set a Start
Channel, etc.
IfyouintendtouseaTLXleforcloningpurposes,youmayalso
congureselectedsettingsintheIPEnvironmentMenu(accessible
from the Installer Menu). See “IP Environment Setup” on pages 56 to
63 for further information. In particular, if you intend to use the Wi-Fi
Zoningfeature,youmustcongurethewirelessnetworkconnection
as part of the Master STB Setup. However, note that you cannot return
directly to the Installer Menu from the IP Environment Menu; thus, you
may wish to set all Installer Menu items as needed before you access
the IP Environment Menu. Otherwise, you will need to reaccess the
Installer Menu to set additional items.
d) After you have adjusted all Installer Menu item settings as required,
press OK once on the Installer Remote to save your changes; then,
press OK again to exit the menu.
Typical Installer Menu
Adjust the value for this
Installer Menu item, as required.
003 BAND/AFC 001
(Continued on next page)
STB_2000 PTC INSTALLER MENU
CPU-CTV
000 INSTALLER SEQ 000
UPN 000-000-000-000 ASIC D279
PTC V1.00.020 STB V3.08.00
 previous next