Filter
Top Products
8
206-4256
STB-2000 Cabling Connections (Cont.)
(Continued from previous page)
While the STB is turning ON and sending the turn ON command to the display, the STB LED blinks at
a constant rate. Once both the STB and the display panel are ON, the STB LED remains lit but blinks
offtwiceinrapidsuccessioneveryveseconds.Therstimageyoushouldseeonthedisplaypanelis
the Setting a Resolution screen from the STB (see “Setting the Video Output Resolution” on page 14).
4. Select the video output resolution (i.e, the STB’s video output format), and complete the appropriate
Commercial Mode setup procedures, as described in this document.
Note: It is recommended that you complete STB-2000 Commercial Mode setup procedures before you
make external equipment connections to the STB-2000.
STB-2000 Cabling Diagram
See also step 2 of procedure above.
MPI
DISPLAY
CONTROL 2
IN 2
IN 1
USB IN 2
USB IN 1
OUT
LAN
DIGITAL
AUDIO
POWER
DISPLAY
CONTROL 1
IR IN
SERVICE
AV IN
AUDIO
LINE OUT
ANTENNA/
CABLE IN
STB-2000 Front Panel
STB-2000 Rear Panel
c) & d) Complete STB Power
and Antenna/Cable connections.
b) Connect HDMI OUT
on STB to HDMI IN on
display panel. **
a) Connect DISPLAY
CONTROL 1 to LG Public
Display or Commercial Monitor
display panel RS-232 port. *
* Only one DISPLAY CONTROL connection
should be used, depending on the type of
display panel to be controlled.
** TheSTBdefaultcongurationautomatically
sends Display Control commands to switch the
connected display panel to its HDMI1 input.
a) Connect DISPLAY
CONTROL 2 to LG Hospitality
display panel MPI port or to
commercial non-LG TV MTI
(DATA) port. *