Filter
Top Products
3 - 2 ONline Ethernet Management Module Installation and Operation Guide
Quick Reference for Getting Started
Table 3-1 outlines the steps and commands necessary to configure your
EMM. The procedures and command examples are explained further
throughout this chapter. If you are familiar with these instructions, you may
want to use this table as a checklist.
Table 3-1. Quick Reference for Getting Started
Procedure Command
1. Configure your terminal to
default
EMM communication settings
❑ Configure EMM Terminal
Settings
Refer to your terminal vendor's
documentation
SET TERMINAL HANGUP
SET TERMINAL PROMPT
SET TERMINAL TIMEOUT
2. Configure the EMM
❑ Concentrator Configuration
❑ Device Configuration (EMM)
SET CONCENTRATOR PLATFORM
SET CLOCK
SET DEVICE CONTACT
SET DEVICE DIAGNOSTICS
SET DEVICE LOCATION
SET DEVICE NAME
SET DEVICE PASSWORD
SNMP Configuration SET COMMUNITY
SET DEVICE DEFAULT_GATEWAY
SET DEVICE IP_ADDRESS
SET DEVICE SUBNET_MASK
SET ALERT
SET DEVICE TRAP_RECEIVE
(Advanced EMM only)