Filter
Top Products
3 - 10 ONline Ethernet Management Module Installation and Operation Guide
Both the administrator and the user password can be a maximum of 15
characters in length. Note that you must enter a password within 10
seconds following the display of the Password: prompt, or the terminal will
display “Timeout.” If this happens, press [CTRL] [R] to redisplay the SET
DEVICE PASSWORD command. The new passwords you set go into effect
immediately, but you must issue the SAVE DEVICE (or SAVE ALL) command
to save the new passwords.
Establishing the Administrator Password
Use the following command to establish the administrator password.
ONline> set device password administrator [ENTER]
Enter current administrator password: {old password} [ENTER]
New password: {new password} [ENTER]
Verify: {new password} [ENTER]
Note: For security purposes, the values you enter in the password
fields are not displayed on the screen.
You do not need to use the new administrator password until the next time
you log in to the EMM.
As EMM administrator, you can configure the following:
❑ Device - This includes naming the EMM, establishing passwords,
setting mastership priority, setting SNMP Values, as well as providing
location and contact information.
❑ Modules - The EMM can assign each module in the ONline System
Concentrator to one of the available networks or isolate it (not
connect that module to any network). Reconfiguration of network
assignments can be done at any time, without removing a module
from the concentrator or disrupting other configuration settings. If a
module is removed from the concentrator slot and replaced with the
same module type in the same slot, the new module will be
configured to the settings of the previous module installed in that
slot.