Filter
Top Products
5 - 4 ONline Ethernet Management Module Installation and Operation Guide
Out-of-Band Download Instructions
The instructions for performing an out-of-band download to the Ethernet
Management Module are divided into the following steps:
❑ Install the ProComm Software
❑ Connect the RS-232 Cable
❑ Download the New Software
Installing the ProComm Software
This step installs and configures ProComm software on your PC hard disk or
onto the FDK diskette if you are using a two-floppy system. The files are
installed in the subdirectory PROCOMM which is created on the hard drive
or on the FDK diskette.
Follow the instructions below to install the ProComm software:
1. Remove the shrink-wrap from the ProComm package and remove the
ProComm Distribution Diskette.
2. Make a backup copy of both the ProComm diskette and the 3Com
provided diskette (the FDK diskette).
3. Place the 3Com diskette in the floppy drive and change to that drive
by typing a: or b:.
4. Type the command FDK and press [ENTER] to display the initial
installation screen as shown in Figure 5-1.
A:> FDK [ENTER]