Filter
Top Products
3 - 24 ONline Ethernet Management Module Installation and Operation Guide
Logging Out From a Remote Session
When you no longer need to be connected to a remote device, enter the
LOGOUT command. This command disconnects the remote connection and
reconnects the session with the local EMM. Once this is done, the local
management prompt returns to the local screen.
If TIMEOUT has been set for the remote EMM and the time runs out, you
will be logged out of the remote EMM and returned to the local EMM.
Unsaved changes are still in effect, but they will be lost if the EMM is reset.
To save these changes, re-establish connection to the EMM and issue the
SAVE command.
Monitoring With SHOW Commands
The EMM enables you to display device (EMM), module, port, and
concentrator configuration settings using the SHOW commands.
Showing Device Information
Use the SHOW DEVICE command to view the current EMM information.
ONline> show device [ENTER]
3Com Advanced Ethernet Management Module (5101M-MGTA)
v4.00.0 AgentOS SNMP
Name: ONline
Location: Wiring Closet 3
For assistance contact: Network Administrator
Boot EPROM Version: v3.2 Serial
Number: 850836 Restarts: 7
Flash EPROM Version: v4.00-A Service Date: 93/06/16
Network
IP Address Subnet Mask Default Gateway
1 * 151.104.002.205 FF.FF.00.00 151.104.002.001
2 151.104.006.214 FF.FF.00.00 151.104.006.001
3 151.104.006.214 FF.FF.00.00 151.104.006.001