Filter
Top Products
3 - 26 ONline Ethernet Management Module Installation and Operation Guide
Showing Port Information
The EMM enables you to display the status of all module ports. Use the
SHOW PORT command to display the mode and status of one port or all
ports. Use the VERBOSE option as shown to display detailed information
about a specific port.
ONline> show port 16.1 verbose [ENTER]
Port Display for Module 5104M-FBP:
Port
Mode Status Network General Information
16.01 DISABLED LINK FAILURE ETHERNET_1
Port Alert Filter: DISABLED
Port Connector: FIBER
Mode Dip Setting: ENABLED
Issue the SHOW PORT ALL command to display information for all ports on
a four-port Fiber Module installed in slot 3.
ONline> show port 3.all [ENTER]
Port Display for Module 5104M-FBP:
Port
Mode Status Network General Information
03.01 ENABLED OKAY ETHERNET_3
03.02 ENABLED LINK FAILURE ETHERNET_3 Port is down
03.03 ENABLED OKAY ETHERNET_3
03.04 ENABLED OKAY ETHERNET_3
Showing Concentrator Information
The SHOW CONCENTRATOR command reports the status of the primary
and backup power supplies and temperature status for that concentrator.
ONline> show concentrator [ENTER]
Concentrator Information:
Concentrator Type: 5017C
Primary power supply status: NORMAL
Backup power supply status: NORMAL
Temperature sensor status: NORMAL