Filter
Top Products
Software Download Instructions 5 - 19
Note: Performing an inband download will end your
remote login session. It will be necessary for you to
remote_login again to check your TFTP result code.
Wait three to five minutes allowing the download to complete before
re-connecting to the EMM. You may then log in remotely to the
EMM. Issue the SHOW TFTP command to display the TFTP Result
Field and verify that the download transfer was successful.
If you are logged into an EMM locally, the download begins once
you enter the administrator password.
When the download completes, the following message is displayed
when the EMM boot up under the new software.
Inband Download Successful
Rebooting System: standby
Ethernet Management Module (vx.xx) Copyright (c) 199x
Chipcom Corporation
Press [ENTER] to display the Password: prompt. Enter the
administrator password to log into the EMM.
If error messages are displayed, refer to the Troubleshooting section
beginning on the next page.
Troubleshooting
This section discusses possible problems you may encounter during the
out-of-band or inband download procedures. The problems are divided into
ProComm Problems and Ethernet Management Module Problems.