Filter
Top Products
5 - 10 ONline Ethernet Management Module Installation and Operation Guide
5. Enter the letter of the drive where ProComm has been installed
following the “Enter the Destination where ProComm resides:”
prompt. For a hard drive installation, this is usually c or d. For a floppy
disk installation, this is the drive where the FDK disk is installed,
usually a or b. Then press the Down Arrow key (↓) or [TAB] to move
to the next field.
6. If the source and destination drive identifiers are correct, press
[ENTER] to begin the installation process. The ProComm Header
screen displays quickly and then the ProComm Status Line screen
appears as shown in Figure 5-5.
Figure 5-5. ProComm Status Line Screen
Follow the next procedure to complete a software download to the EMM.
ALT-F10 VT-100 FDX 9600 N81 LOG CLOSED PRT OFF CR CR