Filter
Top Products
5 - 6 ONline Ethernet Management Module Installation and Operation Guide
7. Enter the number of the communications port (COM1, COM2, etc.)
to which you will be connecting the RS-232 cable on the PC to
perform the software download following the “Enter the COM Port
(1-4):” prompt. Then press the Down Arrow key (↓) or [TAB] to move
to the next field.
Note: If the message “ProComm directory already exists, overwrite
files?” displays, you have the choice of overwriting the files or
quitting the installation. If you enter Y to overwrite the files,
the existing ProComm files are deleted and then the new files
are copied to the selected drive.
If you are performing a two-floppy installation, follow step 8. If you
are performing a floppy-to-hard drive installation, follow steps 9 and
10.
8. Press [ENTER] if the source and destination drive identifiers and the
COM port selection are correct. Then, insert the ProComm diskette in
the appropriate drive and press [ENTER] to install and configure
ProComm directly on the FDK diskette. The floppy installation is
complete when the message “INSTALLATION COMPLETE” displays.
Label the FDK diskette as now having ProComm installed so you can
locate this diskette when necessary.
9. Press [ENTER] if the source and destination drive identifiers and the
COM port selection are correct and the installation process begins.
Insert the ProComm diskette into the diskette drive when prompted
as shown in Figure 5-2.