Filter
Top Products
3 - 4 ONline Ethernet Management Module Installation and Operation Guide
Use the REVERT command to restore the configuration values in effect at
the time of the last save. Any unsaved changes made using the SET
command are lost. The REVERT and SAVE commands support the same
configuration groups as defined below.
❑ Alert
❑ All
❑ Community
❑ Concentrator
❑ Device
❑ Security
❑ Module_Port
❑ Terminal
❑ TFTP
Configuring the Terminal
The terminal that attaches to the serial port on the EMM must be
configured to the same parameter settings as the EMM so the terminal and
EMM can communicate. These settings include baud rate, data bits, parity,
and stop bits. Initially, the terminal settings must match the factory default
settings of the EMM as specified in Table 3-2. Consult the user's guide
shipped with your computer terminal for instructions on how to set these
values