Filter
Top Products
5 - 18 ONline Ethernet Management Module Installation and Operation Guide
6. Issue the DOWNLOAD INBAND command as shown to begin the
download.
ONline> download inband
WARNING: Download will erase your current operational code.
You will need the following to replace the software:
1. Chipcom Management Module Software residing on a TFTP
server accessible over the network.
2. The TFTP variables (see SHOW TFTP and SET TFTP) must be
set up to point to the TFTP server. The DEVICE
varibles (see SHOW DEVICE and SET DEVICE) must be set up
to a valid IP configuration.
3. The serial number of the Upgrade Distribution Kit.
4. Chipcom Key Code, which is provided by completing the
UDK fax form and faxing it to 3Com at (508)
460-6195. Please list your return fax number, your
Upgrade Distribution Kit Serial Number, plus for
non-site licenses: Management Module's ID number:
3658117
If you are positive that you want to perform a network
download, enter the download inband again within 10
seconds. Otherwise, the sequence will be aborted.
7. Press the key sequence [CTRL-R] to redisplay the previous command
and press [ENTER] to begin the download process.
ONline> download inband [ENTER]
Enter Upgrade Distribution Kit Serial number:
8. Enter the serial number from the UDK diskette and press [ENTER].
Enter 3Com Key Code:
9. Enter the Key Code number as supplied from 3Com Corporation and
press [ENTER].
Enter Administrator Password [ENTER]
10. Enter the administrator password and press [ENTER]. Once the
download begins, do not press any keys or interfere with the process.
If you are logged into an EMM remotely, the following message is
displayed. Once this message displays, the remote session is
terminated and the download begins.