JVC HM-DSR100RU Satellite TV System User Manual


 
Page 6-7
Sledgehammer or small fence post driver
Drill and 1/2 inch drill bit - long enough to drill through the exterior wall of your building
Compass *
Silicone sealant (for sealing drill holes) *
Note: You will need additional tools and materials, depending on the type of surface on
which you mount the antenna. Each of the procedures for mounting the antenna lists these.
If you find that you do not have the tools and skills for a certain procedure, call a profes-
sional, such as a satellite television dealer or an electrician, for assistance.
OPTIONAL INSTALLATION KIT
The Installation Kit (VU73457) is an optional product that contains the hardware and
materials that you would typically use to install the system. To buy the Installation Kit,
contact the location where your system was purchased or call the Service Center.
If you did not purchase the Installation Kit, but still plan to install your system yourself, you
should gather the appropriate materials (such as those listed below) before beginning instal-
lation. The Installation Kit contains the following:
Installation Kit Guide
Installation video tape with step-by-step demonstrations
25' telephone cord with RJ-11 connectors
Dual telephone adapter
Telephone coupler, for connecting two telephone cords
8' Triple phono (RCA) audio/video cord
Dual grounding block
30' Grounding wire, either 8 gauge aluminum or 10 gauge copper
25' RG-6 (coaxial) cable with "F" connectors
75' RG-6 (coaxial) cable with "F" connectors
4 Toggle anchors (3" x 1/4"); 4 Double expansion anchors
4 Machine bolts (3" x 1/4")
4 Lag screws (3" x 5/16"); 4 Lag screws (2" x 5/16")
4 Cable ties; 10 Cable clips for the coaxial cable
Starting Your Installation
Optional Installation Kit
6