Filter
Top Products
Page 4-43
DETERMINING THE CURRENT REMOTE SETTINGS
You can find out which code is currently set for each remote mode.
1. Press the Mode button on the remote until the
appropriate mode light is flashing rapidly.
2. Press the
Address button twice.
For SAT mode, the mode light flashes the number of
times that matches the recorder address.
For example, if the recorder is addressed to 4, the mode
light flashes four times.
For TV, D-VHS, and AUX modes, the mode light flashes
the number of times to indicate each digit of the current
code. There will be a pause between the flash sequences
for the digits. A quick flash indicates zero (0).
For example, for an AUX code of 0136, the mode light
flashes once quickly (for zero), then once, three times,
and six times.
Note: Remember that the AUX mode has a 4-digit code.
3. Write all the codes you programmed into the remote on
the sticker on the inside of the remote battery cover, and
on the inside back cover of this Guide.
Note: When you change the batteries in the remote, you
may need to reprogram these codes back into the remote.
Remote Buttons
MODE
Using the System
Programming the Remote Control
4
ADDRESS