JVC HM-DSR100RU Satellite TV System User Manual


 
Page 4-39
PROGRAMMING THE REMOTE CONTROL
You can program the remote to control not only the recorder, but also your TV, and
cable box or amplifier. This remote supports most brands and models; however, there
may be some brands or models that it does not support. You can program the remote to
control a maximum of four different electronic components. Which component is being
controlled by the remote depends on the current mode:
The built-in satellite receiver (controlled in SAT mode)
The TV set (controlled in TV mode)
The built-in video recorder (controlled in D-VHS mode)
One auxiliary item, such as an amplifier, a cable TV box, or a second TV or VCR
(controlled in AUX mode).
The remote is already programmed to control the built-in receiver. However, if you have
multiple receivers and remotes, you may need to set a unique address for the receiver/
recorder, to prevent interference.
Before beginning the following procedures, make sure that all electronic components are
powered ON. Make sure that there are fresh batteries installed in the remote.
Then, do the following:
Using the System
Programming the Remote Control
4
1. Turn ON the piece of equipment you want to program
the remote to control.
2. Find the brand name of the equipment in the equipment
codes table beginning on page 4-44.
Note: If there is more than one code listed for the brand,
try each until the remote is able to control the equipment.
3. Press the
Mode button on the remote until the mode light
that matches the equipment flashes rapidly.
Note: Select the AUX mode for audio amplifiers, cable
boxes, second TVs or second VCRs.
4. Press the
Address button. The mode light continues to
flash more slowly.
Remote Buttons
MODE
ADDRESS