Filter
Top Products
Page 6-8
User and
Installation Guide
ࡗ Compass
ࡗ Silicone sealant
Tools, such as drills or screwdrivers, are not included in the Installation Kit.
INSTALLING BATTERIES IN THE REMOTE
Four AAA batteries, packaged separately, are included with the remote control. See Installing
Batteries in the Remote on page 3-1 for this procedure.
SETTING THE REMOTE ADDRESS
When you get your recorder and remote, they are addressed to 1. Unless you experience
problems, you do not need to change the address at this time. If you want to change the
address, change it to a different number.
You may need to set the remote address in any of the following situations:
ࡗ You have a UHF remote, and you encounter interference caused by other nearby UHF
remotes (for example, a neighbor's UHF remote or a UHF remote being used in another
room of your building).
ࡗ There is another satellite receiver and remote being used in the vicinity.
Note: In either of the above situations, you may need to assign an address to your
remote and recorder, so that the recorder responds only to that remote.
ࡗ Your recorder does not respond to the remote. You must match the addresses to be able
to use the remote. In this case, it could be that the remote and recorder are set to differ-
ent addresses. See Setting the Remote Address on page 3-2 for this procedure.
TEMPORARILY CONNECTING THE RECORDER TO TV
You must connect the recorder to your TV and make sure the Smart Card is installed to get
the information to aim your satellite antenna. In this step, it is not necessary to fully wire
your recorder to all your electronic equipment.
See Wiring Setups on page 7-21 for suggested wiring configurations. The Quick Install on
page 7-22 is the quickest and easiest to set up.