Filter
Top Products
Page 4-38
User and
Installation Guide
DISH SIGNAL DIAGNOSTIC TEST
This test verifies that your system has good signal reception.
Select the
Dish Signal option to begin the test. The recorder displays a message asking
you to wait until the test is completed. If the system signal reception is normal, the
recorder displays a message that says "Signal Reception OK." If the signal reception is
not working correctly, the recorder displays a failure message. In this case, see the
Diagnostic Test section of the Problems and Solutions Tables on page A-18.
TELEPHONE CONNECTION DIAGNOSTIC TEST
Select the Phone Connection option to begin the test. The recorder displays a message
asking you to wait until the test is completed. If the telephone connection is correct, the
recorder displays a message that says "Phone Connection OK." If the telephone is not
connected properly, the recorder displays a failure message. In this case, see the
Diagnostic Test section of the Problems and Solutions Tables on page A-18.
MAIN UNIT DIAGNOSTIC TEST
This test verifies that the recorder is working correctly.
Select the
Main Unit Test option to begin the test. The recorder displays a message
asking you to wait until the test is completed. If the main unit is working correctly,
the recorder displays a message that says "Main Unit OK." If the main unit is not
working correctly, the recorder displays a failure message. In this case, call the JVC
Service Center for assistance.
Note: This test may temporarily distort the TV picture.
3
4
3 Dish Signal
4 Phone Connection
5
5 Main Unit Test