Filter
Top Products
Page 7-5
Installing and Wiring Your System
Installing the Satellite Antenna
7
11.Thread the LNBF cable into the cable hole near
the mast foot, up the mast and out the top of
the mast.
Do not kink or pinch the cable.
12.Take the end of the cable coming out the top of
the mast, and thread it up the support arm.
13.Loop the end of the cable over the pivot bolt.
14.Bring the cable back down on the outside of
the mast sleeve, between the dish supports.
15.Thread the cable through the arm and out the
end of the arm.
16.Adjust the cable so that there are about 2
inches of cable out the end of the arm.
17.Attach the LNBF to the coaxial cable(s).
18.Fit the LNBF into the dish support arm, sliding
it in until it is inserted firmly. You may have to
adjust the cable, pulling it back gently through
the support arm.
19.Attach the LNBF to the support arm, using the
LNBF screw and washer.
2"
Pivot
Bolt
Dish
Support
Mast
Sleeve
Arm
Hole
RG-6
Coaxial
Cable
Mast
Mast
Foot
Direction
to Thread
Coaxial Cable
Cable
Loop
Cutaway View
(dish omitted
for clarity)
LNBF
Connector
Coaxial
Cable
Cutaway
View of Arm
Cutaway
View of Arm
LNBF
Connectors
Coaxial
Cable
Cutaway
View of Arm
Washer
Screw