JVC HM-DSR100RU Satellite TV System User Manual


 
Page 4-40
User and
Installation Guide
5. Use the number pad buttons to enter the first 3-digit code
listed for your equipment brand in the table. The mode
light stops flashing and stays lit.
Note: If you are entering a code for the AUX mode, you
have to enter a four-digit code. The first digit is the code
for the piece of equipment:
0 - indicates a second TV
1 - indicates a second VCR
For example, to program the AUX mode to control a
Sony TV, enter 0 and then 000.
If you are programming for an amplifier or cable TV
box, the codes shown in the table include the first digit.
6. Press the
Address button. If the code you entered is
valid, the mode light blinks three times.
7. Test if the code works for the equipment by pressing the
Power button. If it is the correct code, the equipment
should turn OFF.
8. Turn the equipment back ON and try some other
functions to make sure you have the correct code.
Occasionally the
Power button may work when others
do not.
If the code works, then you can stop here. Write all the
codes you programmed into the remote on the sticker on
the inside of the remote battery cover, and on the inside
back cover of this Guide.
Note: When you change the batteries in the remote, you
may need to reprogram these codes back into the remote.
9. If the code you entered is not correct, repeat steps 4
through 8, using another code from the table.
10.If you have tried all of the codes listed for your
equipment without success, or if you cannot find your
equipment manufacture's name in the table, do the
procedure in The Power Scan: If Your Brand is Not
Listed on the next page.
Note: You have a limited time to program the remote
control after pressing the
Mode button. Start the programming
procedure again if the mode indicator is no longer lit.
123
4
5
6
78
0
9
ADDRESS
POWER