Filter
Top Products
PCS -1/1P
3-207-456-12 (1)
I:\3207456121PCS1WW\08OPE.FM
masterpage:Left
143Using the Display Control
Chapter 7: Multipoint Videoconference
Using the Display Control
During a multipoint videoconference with the MCU software installed in the
communication Terminal you can control the following operations.
You can use the “Split”, “Split (Fixed)”, “Voice Activate” and “Broadcast”
modes.
Split mode
This mode allows display of the pictures from the connected remote terminals
and the picture of the local terminal by splitting the monitor screen.
According to the connected terminals, four-split windows (1 to 3 terminals
connected) or six-split windows (4 and 5 terminals connected) are displayed.
Pictures A to C (or A to E) appear in order of connecting.
• When the six-split window is displayed, the System detects the terminal including the
loudest sound among all the terminals and the picture of that terminal is replaced with
the picture in the lower right window.
• If you switch the broadcast mode from Split mode to Voice Activate mode in which
a picture of a specified terminal is shown in full screen during communication, the
location of Pictures A to E will be changed when the Split mode is restored.
• When your system is in the Split or Split (Fixed) mode, you cannot control the camera
on any connected remote terminals.
What is “Broadcast Mode”?
Notes
Picture A
Four-split window
Picture B
Picture on the local
site
Picture C
Picture on the local site
Six-split window
Picture A
Picture E
Picture D
Picture B Picture C