Filter
Top Products
PCS-1/1P
3-207-456-12 (1)
I:\3207456121PCS1WW\03OVR.FM
masterpage:Left
23Turning the System On/Off
Chapter 1: Installation and Preparation
Turning the System On/Off
This section describes how to turn on or off the Communication Terminal.
1 Turn on the TV monitor.
If the IR repeater is installed in the TV monitor, set the TV monitor to standby
mode. The TV monitor will turn on simultaneously when the Communication
Terminal is turned on.
2 Turn on the power of any other equipment to be used for the
videoconference.
3 Set the power switch on the right side of the Communication Terminal to
the on position (
@).
The Communication Terminal turns on after a while. Three indicators on the
front of the Communication Terminal and the POWER indicator on the camera
light, then only the POWER indicators on both units remain on in green. The
launcher menu will appear on the monitor screen and the picture shot by the
local camera will also appear in the launcher menu.
Launcher menu
Turning On
POWER indicators
(Light in green.)
Power switch
IP:0.0.0.0
ISDN:012345678912
Audio:MIC(INT)+AUX
Video:Main
Connect
Angle Adj.
Phone Book
Dial
Menu
Show Help