Filter
Top Products
PCS -1/1P
3-207-456-12 (1)
I:\3207456121PCS1WW\04SET.FM
masterpage:Left
51Registering Local Information
Chapter 2: Registration and Setup for System Administrators
ISDN UNIT Version
Displays the version of the connected PCS-
B768 ISDN Unit.
DSB Version
Displays the version of the connected PCS-
DSB1 Data Solution Box.
DSP Version
Displays the version of the built-in DSP
(Digital Signal Processor) for audio/video
codec.
Software Option
Displays the optional MCU software
installed.
None: No MCU software is installed.
Multipoint (H.323): The PCS-323M1
H.323 MCU software (for LAN) is
installed.
Multipoint (H.320): The PCS-320M1
H.320 MCU software (for ISDN) is
installed.
Multipoint (H.323& H.320): Both the
PCS-323M1 and PCS-320M1 MCU
software are installed.
Option I/F
Displays the optional connected equipment.
None: No optional equipment is connected.
ISDN UNIT: The PCS-B768 ISDN Unit is
connected.
DSB: The PCS-DSB1 Data Solution Box is
connected.
Whiteboard: A whiteboard is connected.
Host Name
Enter the host name.
IP Address
Enter the IP address.
MAC Address
Enter the MAC address.
Serial Number
Displays the serial number.
The Communication Status menu shows the
current status of communication.
The ISDN or LAN status will also be
displayed depending on the line interface
used.
Communication Status
One page for each point connected to the
system will be displayed. The connected
point is shown at the upper right corner of
the page as “Connection A (or B, C….)”.
The terminal’s name of the point is also
displayed at its side.
Camera Control
Shows whether control of each other’s
camera is enabled or not.
Data Control
Shows whether the T.120 data conference is
enabled or not.
Line I/F
Displays the line interface you are using.
Rate
Displays the number of lines connected and
a transmission rate during communication.
DSB
Shows whether the Data Solution Box is
connected or not.
Whiteboard
Shows whether the mimio Xi attached to
your whiteboard is enabled.
The items below are shown both in the
columns for “Encode” and “Decode”. The
descriptions under “Encode” show the
Communication Status Menu
Communication Status
Audio Mode
Cancel
Video Mode
Frame Rate
LSD Rate
MLP Rate
HMLP Rate
G.728
(Encode)(Decode)
H.261CIF
15FPS
G.728
H.261CIF
15FPS
6400
OFF
62.4K
6400
OFF
62.4K
Camera Control
Data Control
Line I/F
Rate
DSB
Whiteboard
ON
Connection A
ON
BRI
2 x 64K
ON
OFF
Page: 1/4