Filter
Top Products
EKFG – Write command "Configuration of the system"
With this write command the FU will get the channels (analyzers) sending the current
signals and their sequence. Furthermore the FU will get the channels that should be called
with the total channel command "K0" or "KV Ln", i.e. the channels that shall be included to
operation modes like measurement, zerogas and spangas. With the string XYZ the FU will
be told which chemical component or virtual device (e.g. Lambda) shall be combined with
which channel. The string XYZ will be for instance C0, N0, No
x
or BRETT (Lambda
according to Brettschneider) etc. The other physical or virtual channels can only be called
directly with their channel number.
If no component and no channel number will be specified, the FU will get its default confi-
guration of the system. That means, that all physical and virtual available components will
be included to the read and control commands with the total channel command "K0" or
"KV Ln". Besides, the TBCC can get the real physical composition of the FU with the read
command "AKFG".
Write command
EKFG K0 XYZ Kn XYZ Km XYZ Kx
Adjusted channel x, component XYZ
Adjusted channel m, component XYZ
Adjusted channel n, component XYZ
Addressed channel 0
Code
EKFG KV Ln Kn ... Kx
Adjusted channel n to x
Lines getting assigned with adjusted
channels
Addressed channel; front-end computer
Code
Response
EKFG 0
Error status
Code
2 - 90
AK
90003752(1) [AK-Commands] 10/98