Filter
Top Products
2 - 20
AK
90003752(3) [AK-Commands] 11/03
SHDE – Control command "Hold status ON"
SHDA – Control command "Hold status OFF"
We have the possibility to activate the "Hold"-feature not only per calibration. We can do
this also by AK-Command "SHDE". With the command "SHDA" we have the possibility to
deactivate an activated "Hold" again. Starting the command "SHDE" will switch on the
"hold status". So it is possible to start the "Hold"-feature directly by AK command and not
only per calibration. With the "SHDA" command the "Hold status" will be deactivated.
Control command
SHDE K0
SHDA K0
Function associated to the whole system unit
Code
Response
SHDE 0
SHDA 0
Error status
Code