Filter
Top Products
II) V24/RS232/485 Interface - Single Analyzers and Systems
90003752(1) [AK-Commands] 10/98
AK
2 - 19
SGTS – Control command "Device test"
Starting this command the analyzers in a system or the single analyzer will switch off the
calibration gas and the samplegas. That means, all gas tubes to the analyzer device will
be closed and the pumps will be switched off. Then, the device can be checked via a gas
input that is located directly in front of the device.
Control command
SGTS K0
Function associated to the whole system unit
Code
SGTS K1 Kn
Function associated to channel n
Function associated to channel 1
Code
Response
SGTS 0
Error status
Code