Filter
Top Products
II) V24/RS232/485 Interface - Single Analyzers and Systems
ETOL – Write command "Stability tolerances"
With this write command the analyzers in a system, the single analyzer or the front-end
computer will get the required tolerances for functions running stability controlled. The
tolerance will be specified in percent of the end of range value. The tolerance can be
adjusted for each range separately. No tolerance check will be done, if the tolerance value
will be set to T = 100%.
Write command
ETOL Kn M1 Tn1 [...Mm Tnm]
Tolerance channel n, range m in percent of the end of
range value;
tolerance deviation = 2 * tolerance (optional)
Tolerance channel n, range 1
Range 1
Addressed channel n
Code
Response
ETOL 0
Error status
Code
90003752(1) [AK-Commands] 10/98
AK
2 - 101