Filter
Top Products
2 - 46
AK
90003752(1) [AK-Commands] 10/98
AFDA – Read command "Function length"
To this read command the FU will send to the TBCC the following data for the called
channel (device):
∗ The function or procedure times of the function determined in "CODE".
Functions like "SATK", "SLIN", "SLCH", "SALI", "SQEF", "SNGA" or "SEGA" will run time
controlled according to the times T1 to T4 or stability controlled.
Time control: If only T1 is set or if T2 = 0, time control will run with step time T1
(total function time).
Stability control: Times T1 to T4 have to be set.
Read command
AFDA K0 CODE
AFDA Kn CODE
Code for the function
Read of channel n
Code
Response
AFDA 0 T1 (T2 T3 T4)
"Time out"; after this time is over, the procedure will be
canceled and you will get an error message; this time will
start after the wait.
Integration time to get the mean value of one signal.
Stability time: All signals have to be in a certain tolerance
during this time.
Time to wait for: after the switching on resp. changing of
gases or the stepping time of time control.
Error status
Code