Filter
Top Products
II) V24/RS232/485 Interface - Single Analyzers and Systems
90003752(1) [AK-Commands] 10/98
AK
2 - 15
SEGA – Control command "Spangas"
Starting this command the analyzers in a system or the single analyzer will switch on the
calibration valve to spangas and switch on the required pumps. This function will only
check the end point. It will not correct the calibration. If continuous line recorders will be
available, the paper transport will also be switched on.
Control command
SEGA K0
Function associated to the whole system unit
Code
SEGA K1 Kn
Function associated to channel n
Function associated to channel 1
Code
Response
SEGA 0
Error status
Code