Filter
Top Products
EMBU – Write command "Switch levels for autoranging"
With this write command the analyzers in a system or the single analyzer will get for the
called channel (device):
∗ The required values in ppm to switch from one range to another with autoranging.
Write command
EMBU Kn Mn XXX YYY [Mm XXX YYY ...] (optional)
Switching value to change to the bigger range
Switching value to change to the smaller range
Range n
Addressed channel n
Code
Response
EMBU 0
Error status
Code
2 - 96
AK
90003752(1) [AK-Commands] 10/98