Filter
Top Products
ESOL – Write command "Setpoint value with limits"
With this write command the FU will get the required setpoint values with acceptable
deviations for the called channel (device) and subchannel (e.g. heating). If these limits will
be exceeded during the operation, it will cause a changing of the error status byte.
For the actual used devices subchannel "m" will be:
m = 0 Concentration
m = 1 Temperature
m = 2 Pressure
m = 3 Flow
m = 4 Pocket calculator No. 1
m = 5 Pocket calculator No. 2
m = 6 Pocket calculator No. 3
m = 7 Pocket calculator No. 4
These assignations may be changed for devices used in the future !
Write command
ESOL Kn m XXX yyy YYY
Upper limit
Lower limit
Addressed setpoint value
Addressed subchannel m
Addressed channel n
Code
Response
ESOL 0
Error status
Code
2 - 98
AK
90003752(1) [AK-Commands] 10/98