Filter
Top Products
2 - 30
AK
90003752(3) [AK-Commands] 11/03
SPAU – Control command "Pause"
With this command the FU will be set to a defined status of interruption. This command will
only be accepted, if the FU is already in the stand-by mode. The "SPAU" command will
switch off the operation modes (e.g. FID flame, pump of an NO device) or the
corresponding setpoints (e.g. temperature of the hot pipe). With the control command
„Reset“ or „Stand-by“ the FU will change to the stand-by mode to get ready for operation.
The real functionality of the "SPAU" command will depend on the used FU. It is part of
each device or system specification.
Control command
SPAU K0
Function associated to the whole system unit
Code
SPAU Kn
Function associated to channel n
Code
Response
SPAU 0
Error status
Code