Filter
Top Products
2 - 28
AK
90003752(3) [AK-Commands] 11/03
SNGA – Control command "Zerogas"
Starting this command the analyzers in a system or the single analyzer will switch on the
zerogas valve and the pumps necessary for the zerogas transport. This function will only
check the zero point. It will not correct the calibration. If continuous line recorders will be
available, the paper transport will also be switched on.
Control command
SNGA K0
Function associated to the whole system unit
Code
SNGA K1 Kn
Function associated to channel n
Function associated to channel 1
Code
Response
SNGA 0
Error status
Code