Filter
Top Products
2 - 62
AK
90003752(1) [AK-Commands] 10/98
Only for MLT analyzers: ALIK – Read command "Output of the linearization curve"
To this read command the x/y values of the linearization curve will be sent. With this
values can be determined the desired segment of the linearization curve and the interval
between the function values.
Read command
ALIK Kn a b c
Interval between the function values [ppm]
End concentration of the segment [ppm]
Beginning concentration of the segment [ppm]
Read of channel n
Only one channel can be checked (no K0).
Code
Response
ALIK s y1 x1 y2 x2 y3 x3...
Raw value No. 3
Setpoint value No. 3
Raw value No. 2
Setpoint value No. 2
Raw value No. 1
Setpoint value No. 1
Error status
Code