Filter
Top Products
2 - 4
AK
90003752(3) [AK-Commands] 11/03
If it is possible in a system to put single channels together to lines, so the following
definition will be valid:
A line is the summary of "1-x" analyzers to a logical group "y", that can be switched
physically to a gas channel "z". Each device can only be assigned to one line at the
same time. If you will try to assign a channel to another line and this channel is already
assigned, the front-end computer will send as response "DF" (data error).
The organization of each defined line will be done in the front-end computer (CODE KV
Ln ...). The order must be sent to the front-end computer "KV".
A line will be dissolved by the configuration without assignment of channels (CODE KV
Ln) or by the reset order (SRES).
All available gas inputs can be assigned to a defined line. So it is possible to assign
different lines to different gas sampling points, e.g. in front of a catalyst, behind a
catalyst. If the gas running time will change in such cases, you have to regard for it.