Filter
Top Products
2 - 32
AK
90003752(3) [AK-Commands] 11/03
SREM – Control command "Remote"
With this command the FU will change to the computing operation mode. Then, the
function start will only be possible by the TBCC. This operation mode may only be set, if
the service switch of the FU is in the position "Remote Enable".
Control command
SREM K0
Function associated to the whole system unit
Code
SREM K1 Kn
Function associated to channel n
Function associated to channel 1
Code
Response
SREM 0
Error status
Code