Filter
Top Products
II) V24/RS232/485 Interface - Single Analyzers and Systems
90003752(1) [AK-Commands] 10/98
AK
2 - 33
SRES – Control command "Reset"
With this command the FU will get a software reset. This command has the same effect to
the FU like the switching off and on of the power supply. All running procedures will be
canceled. An initializing will be started, e.g. check and control of temperature setpoints.
After that the operation modes "Manual" and "Stand-by" will be enabled.
Control command
SRES K0
Function associated to the whole system unit
Code
SRES Kn
Function associated to channel n
Code
Response
SRES 0
Error status
Code