Filter
Top Products
II) V24/RS232/485 Interface - Single Analyzers and Systems
90003752(1) [AK-Commands] 10/98
AK
2 - 37
STBY – Control command "Stand-by"
With the command "Stand-by" the FU will be set to a defined status of interruption.
Running functions like measuring or purging will be canceled. Then, the stand-by mode will
be enabled. The ranges will keep selected. The FU will get ready for measurement and
operating, no matter which mode was the previous.
Control command
STBY Kn
Function associated to the whole system unit
Code
Response
STBY 0
Error status
Code