Filter
Top Products
II) V24/RS232/485 Interface - Single Analyzers and Systems
90003752(1) [AK-Commands] 10/98
AK
2 - 7
2.3. Write commands
CODE
Function Page
EFDA Kn CODE
DATA
Zero- /spangas time (function length of calibration) 2 - 85
EFDA Kn CODE Purge time 2 - 85
EGRW Kn DATA Limits 2 - 87
EKAK Kn Mm
DATA
Calibration gas concentration (in ppm)
Value = 0: no spangas available
2 - 88
EKFG Kn DATA Configuration of the system 2 - 90
ELIN Kn Mm
DATA
Linearization values in the device (X/Y = Setpoint-/raw value) 2 - 91
ELKO Kn DATA Polynomial coefficents of the linearization curve 2 - 92
ELST Kn DATA Linearization steps 2 - 93
EMBA Kn Mm
DATA
Begin of range (in ppm)
Value = 0: no range defined
2 - 94
EMBE Kn Mm
DATA
End of range (in ppm)
Value = 0: no range defined
2 - 95
EMBU Kn DATA Switch levels for autoranging 2 - 96
EMDR Kn DATA Manual adjusted pressure 2 - 97
ESOL Kn m DATA Setpoint value with limits 2 - 98
ESYZ Kn DATA System time (year, month, day, hour, min., sec.) 2 - 99
ET9O Kn DATA T90 time (response time) 2 -100
ETOL Kn Mm
DATA
Stability tolerances 2 -101
EVEZ Kn DATA Delay and synchronization time 2 -102
EZEI Kn CODE
DATA
Times (for procedures) 2 -103
Optional:
EKEN Kn DATA Device tag 2 - 89
Kn:
Channel n
Mm:
Range m
Response
The response to the write commands will contain the CODE of the write command and
the error status byte (0 - 9).