Filter
Top Products
2 - 22
AK
90003752(3) [AK-Commands] 11/03
SLCH – Control command "Linearization check"
Starting this command the analyzers in a system or the single analyzer will switch on the
gas tubing to a gas distribution and a linearization procedure will run. The device will
record the correction values to the receiver specific raw curve. The deviations to the
correction values of the last determined linearization will be stored. Look at the command
"SLIN" for informations about the logic of the device control and of the gas distribution
control.
Control command
SLCH Kn Mn
Range n
Function associated to channel n
Code
Response
SLCH 0
Error status
Code