Filter
Top Products
II) V24/RS232/485 Interface - Single Analyzers and Systems
90003752(1) [AK-Commands] 10/98
AK
2 - 25
SMAN – Control command "Operation mode MANUAL"
With this command the FU will change to the operation mode "Manual". Then it will only be
possible to start functions from an operating unit integrated in the FU. The same operation
mode will be enabled, if the service switch of the FU will be in the position "Remote
Disable". In that mode it will only be possible to answer to read commands of the TBCC.
Control command
SMAN K0
Function associated to the whole system unit
Code
SMAN K1 Kn
Function associated to channel n
Function associated to channel 1
Code
Response
SMAN 0
Error status
Code